Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

This section introduces SEVEN ways of making IP devices connect to HDMS depends on TWO scenarios.

Table of Contents
minLevel1
maxLevel6
outlinefalse
styledefault
typelist
printabletrue

Scenario A

If the default P value of HDMS in the configuration file of a device is set in advance, it will connect to HDMS automatically after powering up. You just need to upload the info of devices in HDMS, follow the steps below.

...

In Device Management -> Device List, the Status shows the connection between the device and HDMS. Offline means the device is disconnected. Unregistered or Registered means the device is connected.

Info

In Status, Offline means the device is disconnected. Unregistered or

...

Registered means the device is connected.

...

Scenario B

If the default P value of HDMS in the configuration file of a device is not set in advance, a device has to request and get a configuration file, which contains the parameters of HDMS, from a server. You have SIX options.

...

Info

Set a proper name of the configuration file. For more details of roles about naming, please check this DOCUMENT.

  1. Power up the device/ Reboot the device/ Click Auto Provisioning Now on the device’s web page.

Deploy Devices via HPT

If RPS is used by a PBX, sending the configuration file to devices via HPT is a good choice. Follow the procedure below.

...