This section introduces SEVEN ways of making IP devices connect to HDMS depends on TWO scenarios.
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Scenario A
If the default P value of HDMS in the configuration file of a device is set in advance, it will connect to HDMS automatically after powering up. You just need to upload the info of devices in HDMS, follow the steps below.
...
| Info |
|---|
In Status, Offline means the device is disconnected. Unregistered or Registered means the device is connected. |
Scenario B
If the default P value of HDMS in the configuration file of a device is not set in advance, a device has to request and get a configuration file, which contains the parameters of HDMS, from a server. You have SIX options.
...
0: Do not choose one when adding a device in the list.
1: Do choose one when adding a device in the list.
AP: Auto Provisioning.
Site | Account | ResultDescription |
|---|---|---|
0 | 0 | Type in You have to enter UID and PIN after AP on the LCD of the device.The device is not assigned to any site or account. |
1 | 0 | Type in You have to enter PIN after AP on the LCD of the device.The device belongs to a site, but has to type PIN to register an account. |
0 | 1 | Type in You have to enter UID after AP on the LCD of the device.The device has to type UID to get set in a site. Then the device is assigned to a site and accounts. |
1 | 1 | (None)The device is assigned to a site and accounts after AP. |
Power up the device/ Reboot the device/ Click Auto Provisioning Now on the device’s web page.
...