...
If you have set the Web Browser exe file path, then when you press Ctrl and click the IP address of the device, the HPT will help you open the web browser to login to the phone.
...
3.5 HTTP and PNP servers (Servers/Setting page)
On this page, you can turn on an HTTP server and use it as a configuration file server and/or firmware server. Also you can turn on the PNP server to automatically provision phones.
You can also change HPT user interface language and log setting on this page.
...
3.5.1 HTTP Server
...
3.5.1.1 Built-in Server
- Select Built-in Server and Click Start to start the built-in HTTP Server
...
3.5.1.2 External Server
- Select External Server and Cfg Server Path fill in the server path where the configuration is stored
4. Quick Use
NOTE: All operations shown below are proceed in "Mac Mode". "Pin Mode" is not supported right now.
...
- To start build-in HTTP server, you need to fill in the port edit area with appropriate port, and then click "Start" to run. If the port is not available, it needs to be modified.
- While choosing external Server, you need to fill in a configuration file server address (Cfg Server Path
), such as "http://192.168.0.150:80/cfg" (without "/" at the end). Make sure that this path is accessible. - Start PNP server. For the Htek phones, fill "Listen to" box with "224.0.1.75" and fill "Port" box with "5060". Do Not Change These Two Parameters If You Do Not Know What These Mean.
...